INSTALLATION
Page 3-22
CAUTION: The SQE must not be enabled when the MT-800 is attached
to an IEEE 802.3 compliant repeater or equipment meeting Ethernet
Version 1.0 specifications.
Set the SQE switch as follows, using a pen, small screwdriver or
similar object:
•
To enable the SQE test function slide the SQE Switch to the on
position (|), as indicated on the front of the MT-800.
•
To disable the SQE test function, slide the SQE switch to the
off position (O), as indicated on the front of the MT-800.
Figure 3-1. SQE Switch
3.2.2
Setting the Loopback Function
The Loopback (LBK) Select switch (Figure 3-2) allows the MT-800 to
be configured for use in the stand alone mode or as part of a larger
network. If the MT-800 will be used in the stand alone mode, the LBK
function must be enabled. The MT-800 is shipped with the loopback
function disabled.
NOTE: SQE function is disabled if the LBK function is disabled
Set the LBK select switch as follows, using a small screwdriver, pen or
similar object:
•
To enable loopback function, move the LBK switch to the on (|)
setting.
•
To disable loopback function, move the LBK switch to the off
(O) setting.
SQE
DISABLE ENABLE
Front matterBook Page 22 Thursday, January 25, 1996 12:06 PM
