INSTALLATION
Page 3-21
CHAPTER 3
INSTALLATION
This chapter outlines the steps for installing the Cabletron Systems
MT-800. Be sure the guidelines and requirements in
Chapter 3,
Installation Requirements
, and all the specifications and requirements
outlines in
Chapter 2, Specifications
, are met before installing the
MT-800.
3.1
UNPACKING THE MT-800
Before you install the MT-800, you should check the contents of the
accessory package.
1.
Carefully remove the MT-800 from the shipping box.
2.
Remove the MT-800 from the packing material and its protecting
plastic bag. Be sure to save the shipping box in the event the
MT-800 has to be reshipped. Set the transceiver aside to prevent it
form being damaged.
3.
Remove the plastic bag containing the accessories and check that it
contains the following items:
One standard 3 prong USA power cord
One Cable Support
Ten Cable Ties
4.
Inspect the MT-800. If any damage appears to have occurred, call
Cabletron Systems Technical Support immediately.
3.2
SETTING THE SWITCHES ON THE MT-800
Before installing the MT-800, set the SQE switch, the Loopback switch,
and input power as described below.
3.2.1
Setting the SQE Switch
The
SQE
Test switch (Figure 3-1) allows you to enable or disable the
SQE or “heartbeat” test function. The
SQE
switch is the two position
switch on the front of the MT-800. The MT-800 is shipped with the SQE
disabled.
Front matterBook Page 21 Thursday, January 25, 1996 12:06 PM
