Installing the EPIM-3PS
Page 3
Installing the EPIM-3PS
To install the EPIM-3PS into a Media Interface Module
(MIM):
1.) Remove the mounting screw shown in Figure 1.
Note
: When removing an EPIM, be sure to pull the module
straight out to prevent damage to the connector.
2.) Remove the coverplate or the EPIM (whichever
applies).
3.) Slide your EPIM-3PS into place, making sure that the
connectors on the rear of the EPIM are fully engaged
with the connectors on the MIM.
4.) Reinstall the mounting screw.
EPIM-3PS Book Page 3 Tuesday, August 18, 1998 8:42 AM