Connecting the EPIM-3PS to a BRIM
Page 5
Connecting the EPIM-3PS to a BRIM
To connect an EPIM-3PS to a BRIM:
1.) Plug one end of the Ethernet cable (P/N 9372088) into
the EPIM-3PS (Figure 2).
2.) Plug the other end of the cable into the BRIM.
3.) After returning the MIM to the MMAC, returning power
to your hub, and reconnecting to the network, the
BRIM is now ready for operation.
Note
: To disconnect the Ethernet cable from the
EPIM-3PS, carefully insert a small flat screwdriver between
the clip on the connector and the circuit board.
EPIM-3PS Book Page 5 Tuesday, August 18, 1998 8:42 AM