Cabletron Systems CSMIM2-16, Руководство по установке

Страница: 68 / 100

Chapter 4: Troubleshooting Procedures
4-8 CSMIM2 Installation Guide
Table 4-5 Errors from Last Open Request
Table 4-6 Errors from Last Read Request
Table 4-7 Errors from Last ERPC Layer Invocation
ARP errors
Address Resolution Protocol (ARP) errors indicate that
the CSMIM2 is configured to boot from a specified host,
but the host would not transmit its Ethernet address to the
CSMIM2. Possibly, the CSMIM2 configuration includes
the wrong IP encapsulation.
ERPC layer errors See Errors from Last ERPC Layer Invocation below.
Aborts rx’d
The host’s BFS transmitted an abort in response to the
CSMIM2’s Open Request. This often means that the
requested file does not exist on that server. Run erpcd -D
on the host to obtain more information.
Msgs with wrong size
The correct host responded to the Read Request, but the
data size is incorrect.
ERPC layer errors See Errors from Last ERPC Layer Invocation below.
Aborts rx’d
The host’s BFS transmitted an abort in response to the
CSMIM2’s Read Request. Run erpcd -D on the host to
obtain more information.
H/W errors
The CSMIM2 sensed a hardware error during
message transmission or reception. This error
indicates a fault with the CSMIM2 network interface.
Use the net command to isolate the problem (see
Chapter 3).
Msgs from wrong host
The CSMIM2 received a message from an incorrect
host. This indicates that the CSMIM2 received, and
ignored, an unsolicited packet.
Rsp T/O’s
The CSMIM2 never received a correctly formatted
response from the correct host, or any response
from any load server hosts.
Msgs of wrong type
The correct host sent a message to the CSMIM2,
but the message was not a correctly formatted
response to the transmitted request.