imPoRtant safety instRuctions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves or
other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarised or grounding-type plug. A
polarised plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third
prong are provided for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles and the point where they exit from the apparatus.
11. Only use attachments or accessories specified by manufacturer.
12. Use only with the cart, stand tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of
time.
14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
installation
start by removing the existing ir receiver module from the endpoint by
unplugging its 3.5mm jack plug. For MediaStar Compact 751 units, the built
in ir receiver may be currently used, so there may be no external ir receiver
jack plug to remove.
Insert the 3.5mm jack plug of the Wired Remote Control into the endpoint’s
jack socket.
as each key is pressed, the red light on the front of the Wired remote Control
will flash once. The MediaStar endpoint unit should respond in the same
manner as if the infra-red remote control is used. If it does not respond, then
the appropriate ir address mode should be programmed into the Wired remote
Control Unit, as described below.
Note:
when using the 514 with a MediaStar Pro 507 unit using V6 (or earlier)
software, use the INFO key instead of the NEXT key when prompted in the 507
on-screen menus (pressing OK on the 514 will have no effect).
PROGRAMMING THE IR ADDRESS
1. Unplug the Wired Remote Control 3.5mm jack plug from the endpoint
unit.
2. Press and hold down the Green and INFO buttons at the same time.
3. Plug the 3.5mm jack cable back into the endpoint unit with the buttons still
pressed down. The red LED will then be illuminated to indicate the unit is
in Programming Mode. Release the Green and INFO buttons.
4. The unit is now awaiting entry of the MediaStar endpoint type to operate
with:
• Press 1 for MediaStar Pro (507)
• Press 3 for MediaStar Evolution (760, 760/xM)
• Press 5 for MediaStar Compact (751)
5. Once a number key has been pressed, the LED will flash the
corresponding number of times to confirm selection of that IR Address.
6. The Wired Remote Control will then return to normal operation, with a
single LED flash each time a key is pressed.
Page 2
Page 3
