MATRIX SYSTEM AND CONTROL SYSTEM
CONNECTION - RS-485
PC RS-485, multi-Matrix (up to 32) connections are as shown below.
NOTES
:
1. RS-485 baud rate: 9600bps, 8-bit data transmission address, no, odd,
or even parity 1-bit stop address: (9600 – 8 - N - 1).
2. Connect PC RS-485 port to the Matrix RS-485 port:
TX (+) TX (+)
TX (-) TX (-)
RX (+) RX (+)
RX (-) RX (-)
3. Serial connection between Matrix RS-485 ports:
TX (+) TX (+)
TX (-) TX (-)
RX (+) RX (+)
RX (-) RX (-)
4. DIP switch 1-5 addresses must not set to same ID address.
Step 2: First select the Output number keys 02, 03 and 05 to the
right, and select the Input number key 01 to the bottom.
Then, consecutively press the previously selected Output
number keys 02, 03 and 05 (or press the Deselect all
output key). This selects Input 01 to be routed to Outputs
02, 03, and 05.
Step 3: First select the Output number key 06 to the right, and
select the Input number key 03 to the bottom. Then, press
the previously selected Output number key 06 (or press
the Deselect all output key). This selects Input 03 to be
routed to Output 06.
Example 2
(Video Only Switching):: Using a SW808HD matrix having all
the input/output ports properly connected to the equipment. To set the
input/output connectors to switching from video channel 1 to output
channels number 1, 6 and 7 and also to switch from audio channel 2 to
output channel 8. There are two ways of operations:
First method
: In the lower right corner of the blue area, enable the Video
and disable the Audio functions (check/uncheck the white boxes). To
complete the switching operation, click on the corresponding icons
corresponding directly to the INPUT number key 01 and the OUTPUT
number keys 01, 06, and 07 on the matrix to turn them into .
Second method:
The following 4 steps, completes the operation of
switching video channel 1 to output channels 1, 6, and 7 while also
switching audio channel 2 to output channel 8.
Step 1: In the lower right corner of the blue area, enable the
Video and disable the Audio functions (check/uncheck
the white boxes).
Step 2: Select the output number keys 01,06 and 07 to the right
and select the input number key 01 to the bottom.
Then, press the previously pressed output number keys 01,
06, and 07 to the right (or press the Deselect all output
key). This selects video switching of input 01 to utput 01,06
and 07.
Step 3: In the lower right corner of the blue area, disable the
Video and enable the Audio functions (uncheck/check
the white boxes).
Step 4: Select output number key 08 to the right and input
number key 02 to the bottom. Then, press again the
previously pressed output number key to the right (or
press the Deselect all output key). This selects audio
switching of input 02 to output 08.
PC
RS-485 Terminal
RS-485
RS-232
ID
RS-485 Terminal
RS-485
RS-232
ID
RS-232
ID
RS-485 Terminal
RS-485
RS-232
ID
RS-485 Terminal
RS-485
Thirty-two (Slave)
Terminator ON
Thirty-one (Slave)
Second (Slave)
First (Master)
Terminator ON
*The terminal
resistance in an
intterfance
that PC offers
must be
opened