11
Tools Required:
Torque Wrench or Adjustable Wrench, Leak Testing Solution and Screwdriver
ASSEMBLY
1. Read assembly instructions, and understand sequence of assembly, before commencing to assemble
your cooker.
2. The casting for your cooker must be installed into the unit as instructed below before use.
Casting Installation:
A) Remove top nut from casting bolt. Leave bottom nut attached and tightened (if applicable.)
B) Place the casting bolt through the hole on the flat bar casting support bracket as pictured below. The
venturi tube of the burner should be located underneath the windshroud. The venturi tube of the burner
should also be positioned under the horizontal plating on the cooker frame to protect the wire harness
assembly of the gas shutoff system. For cookers supplied with a heat plate, place the heat plate onto the
casting bolt beneath the flat bar casting support bracket. The copper tubing located underneath the casting
must be routed through the cutout provided on the heat plate.
C) Reinstall nut to casting bolt. Tighten. Check to see if casting is pointing straight up and is sturdy.
* Above Figure Does Not Show Hose/Valve Assembly
Which Will Be Pre-Assembled to the Casting
3. Refer to Figure 2 below for picture of a properly installed burner/gas train assembly.
Bottom Nut
(If Applicable)
Top Nut
Casting Bolt
Venturi Tube
Windshroud
Flat Bar Casting
Suppport Bracket
Copper Tubing
Horizontal
Plating
Venturi Tube
Positioned Under
Horizontal Plating
Heat Plate
(If Applicable)
FIGURE 2
* Model May Vary From Picture
* Model May Vary From Picture
Содержание 551306
Страница 31: ...NOTES 30 ...
Страница 32: ...NOTES 31 ...