CABASSE Stream Amp 100, Руководство пользователя

Страница: 6 / 24

e n g l i s h
28
QUICK PLUG & PLAY
Place the STREAM AMP on a solid shelf
close to a mains plug, with enough available
headroom above, under and around, for the
optimum efficiency of the Bluetooth and
WIFI antennas and proper ventilation of the
amplifier.
Connect 2 or 4 loudspeakers to the
STREAM AMP. For a single pair of
loudspeakers, use SP1 (right speaker) and SP2
(left speaker) binding posts.
CAUTION: be assured that all “+” inputs are
effectively connected to “+” outputs as well as
all left outputs to left inputs.
Impedance range selector:
Position “I” (factory preset): power output is 2
x 50 W or 4 x 25 W RMS for loudspeakers with
a minimum impedance value below 6.4 ohms.
It goes down to 2 x 25 W and 4 x 12.5 W for
loudspeakers with minimum impedance value
above (or equal to) 6.4 ohms.
Position “II” : use this position to get 2 x 50 W
or 4 x 25 W RMS with minimum impedance value above (or equal to) 6.4 ohms, for instance
Cabasse Antigua IW or Archipel models.
Connect the power cable to the STREAM AMP, plug it to the mains and position the POWER
ON/OFF switch on "ON". STREAM AMP is ready to play when the LED
1
turns on. Press key 1
either on the STREAM AMP or the remote to get STREAM AMP on.
NOTE: the DLNA mode of STREAM AMP is available when the PWR (Power) LED has turned
from red to green, around 40 seconds after powering on the STREAM AMP.
2
1