11
2.4.3
Mounting the Safety Covers
!
Caution!
Risk of injury!
Without safety covers or with improperly mounted safety covers the reliability and machinery safety cannot
be guaranteed.
Equip the stacker only with safety covers designated for the media to be used.
Mount the safety covers in the correct position.
2
5
6
8
7
9
1
3
3
5
4
4
Figure 9
Mounting the safety covers
i
Note!
For a table width greater than 95 mm for ST4/L or 80 mm for ST4/M no safety covers are needed.
At ST4/L mount safety cover (5) only.
At ST4/M mount two safety covers (2,5).
For it :
1. Open cover (1).
2. Loosen each one screw (5) in the side plates (6,9) several turns.
3. Place the hooks (3) of the safety covers (2,8) into the slots (7) and slide the slots (4) under the screw heads (5).
4. Tighten the screws (5).
5. Close cover (1).
