8
8
2
Installation
2.1
Unpacking
Check stacker for damage which may have occurred during transport.
Check delivery for completeness.
Contents of delivery:
•
Stacker with cutter
•
Documentation
i
Note!
Please keep the original packaging in case the printer must be returned.
!
Attention!
The device and printing materials will be damaged by moisture and wetness.
Set up label printer with stacker only in dry locations protected from splash water.
2.2
Preparing the Printer
1
2
4
3
5
6
7
8
Figure 5
Preparing the printer
Removing Tear-off Plate, Dispense Plate or Rewind Guide Plate
1. Loosen screws (2) several turns.
2. Slide plate (1) to the right and remove it.
Removing Cover or Present Sensor
1. Loosen screw (4).
2. Remove cover (3) or present sensor.
Removing the Locking System
1. Position printer at edge of table so that the oblong hole is accessible from below.
2. Screw out screws (6,8) and remove them.
3. Remove the pinch roller (5) and bottom plate (7).
