CAB 4214 Series, Руководство по обслуживанию

Страница: 12 / 42

12 12
3.3 Movement of the Pad
The applicator 4214 has different takeover modes. The position of the pad is also adjustable.
The base position of the pad will be described in

„6.1 Adjusting the Pad“. The kind of takeover mode is dependant
on the label size and material. The standard takeover procedure occurs without the intermediate steps of the "take
over from above" application mode.
No Movement of the pad
Label
hand-over
up,
apply 0°
swing Label
hand-over
up,
apply 90°
swing Label apply
0° swing
*
Label apply
90° swing
*
1
Pad moves to the dispensing plate of the
printer
(take up of the label)
X X
2
Pad departs from the dispensing plate of the
printer
X X
3
Pad pivots out via the rotation cylinder
X X X X
4
Pad moves to the intermediate position
below the dispensing plate of the printer and
stops
X X
5
Pad will pivot back via the rotation cylinder
X X
6
Pad moves to the product un-pivoted and
applies the label
X X
7
Pad moves to the product pivoted and
applies the label
X X
* Takeover of the label via vacuum and support air with a set distance between the pad and dispensing plate.
Table 2 Phases of pad movement
1
2
4
6
5
3
7
Dispensing plate
of the printer
Product
Hand-over up switch aktive on/off
Menu navigation:
>
Setup
> Labeling
> Label hand-over : Passive / Active
Label swings out and applies
This function will be controlled by the I/O
interface of the printer.
The signal LBLROT ( EDR - ) on Pin
24 will be used to control this function.

Operator's Manual of the printer
Fig. 8 Movement of the pad
3 Operation