CA RING TOSS, Стандартное рабочее руководство

Страница: 30 / 46

Coastal Amusements Inc. | Ring Toss
30
TROUBLESHOOTING
1. NO POWER: Make certain the game is plugged into the mains and the mains are “live”.
Make certain the power part of harness (white 16-gauge wires with 2-pin Molex connector)
at the console has been connected and the interlock switch in the console is in the up (on)
position. Check rear power module to be certain the switch is on. Check fuse inside power
module, replace if damaged.
2. HOPPER ERROR: Should game-play stop and this error appears on the monitor: “HOPPER
ERROR”, the hopper has been running for longer than 15 seconds without seeing any rings
pass into the trough. This error can be caused by one or more of the conditions listed
below. After the condition has been cleared, press the rest button and close the console
lid to restart the hopper. A hopper error can be caused by one or more of the following
conditions:
A. One or more rings have become wedged at an angle just below the hopper exit and is
blocking the optical sensor. Open console lid to access this area. Remove ring, press the
reset button and close the console lid.
B. An error can occur when too many rings get stuck on the hopper side of the trough
wall. Lifting the console lid will allow access to the hopper side of the trough. Clear
rings, press the reset button and close the console lid.
C. A ring jam can occur within the lower part of the hopper, this may indicate too many
rings are in “reserve” at the bottom. Loosen rings by hand, press the reset button and
close the console lid.
D. Rings get under the hopper disk. Should this be the case, remove ALL rings from the
hopper. Gently/slowly rotate hopper wheel (counter clockwise) to allow rings
underneath to be removed. This may prove difficult if some rings are wedged firmly.
Check bottom of hopper to make certain it is free of debris. Once all rings have been
removed from under the wheel and the wheel is flat and rotating freely (by hand),
reload the rings, press the reset button and close the console lid.
E. Should the game run out of rings (all rings are on bottles), hopper error will appear
since no rings are passing by the hopper sensor. This is a rare ‘starvation’ occurrence