Instruction Booklet
7-Series
14
Here are some suggestions about solving problems you may have with your scooter. There
is a self-diagnostic warning light on the control panel. To check the self-diagnostic warning
light, turn on the key and count the number of blinks on the warning light.
TROUBLE SHOOTING
SCOOTER WON’T MOVE WHEN KEY IN TURNED ON
ERROR CODE
Flash
Description
Initial check points
1
Battery Low
The batteries are running low.
•
Recharge the batteries.
3
High Battery Fault
Battery voltage is too high. This may occur if overcharged and/or
traveling down a long slope.
•
If traveling down a slope, reduce your speed to minimize the
amount of regenerative charging.
7
Speed Pot
The throttle, speed limit pot. SRW or their associated wiring may be faulty.
•
Check the throttle and speed pot and associated connections and wiring.
8
Motor Voltage
The motor or its associated wiring is faulty.
•
Check the motor and associated connections and wiring.
9
Other Error
The controller may have an internal fault.
•
Check all connections and wiring.
6
Drive Inhibit
Either a stop function is active or charger inhibits or OONAPU
condition has occurred.
•
Release the stop condition (seat raised etc.)
•
Disconnect the battery charger.
•
Ensure the throttle is in Neutral when turning the controller on.
•
The throttle may require re-calibration.
5
Park Brake
Either a park brake release switch is active or the park brake is faulty.
•
Check the park brake and associated connections and wiring.
•
Ensure any associated switches are in their correct positions.
4
Current limit time-out
or controller overheat
The motor has been exceeding its maximum current rating for too long.
•
The scooter may have stalled. Turn the controller off, leave for a few
minutes and turn back on again.
•
The motor may be faulty. Check the motor and associated
connections and wiring.
2
Low Battery Fault
The batteries have run out of charge.
•
Recharge the batteries.
•
Check the battery and associated connections and wiring.
Check point
Check if the power is off
Check if the N-D lever is in Neutral position
Check if the battery power is enough.
(Battery gauge is under 25%)
Check if the charger power cord is still
plugged in scooter
Solution
Turn the power on.
Switch to D (drive) position. Turn off the power
and turn on again.
Recharge the battery and then retest.
Unplug the charger power cord.
•
TIRE : Low tire pressure: pump up tires to 30~40 psi.
•
Charger : During charging, light on charger doesn’t change to green. Please refer to
section 5-2.
OTHER PROBLEMS
