3
CS
4
PI
overview
The CS4PI is a high performance metal detector operating on the
‘PULSE INDUCTION MOTION’ principle.
Optimum performance is achieved by adopting a steady sweep speed.
The CS4PI is an ‘all-metal’ detector which can operate effectively on ground
conditions (notably waterlogged areas or wet salt beaches) where conventional
discriminator metal detectors may be virtually unuseable. The CS4PI is
designed to offer extremely high performance whilst being easy to operate. We
wish you good hunting and a great hobby with the excellent CS4PI!
Follow these simple steps to start using the CS4PI within minutes . . .
1) Assemble the CS4PI by inserting the lower stem into the upper stem.
2) Rotate the lower stem so that the search-head cable is coiled around the stem as shown in the photo.
3) Twist the locking device so that the stem is locked into position at the required length.
4) Remove the battery compartment cover by loosening the four retaining screws.
5) Fit 8 x AA batteries to the battery holder being careful to observe polarity and good contact.
6) Switch on and rotate the sensitivity control to the green section marked on the scale.
7) Rotate the Pulse Frequency control to the start of the green zone on the scale. With the search-
head off the ground and well away from any metal object listen for interference. If necessary switch to
a different frequency within the green zone where the detector is silent and interference free.
8) START DETECTING . . . metal targets give an audio signal from the loudspeaker accompanied by
illumination of the LED indicator . . . maintain a steady sweep speed swinging the search-head from
side to side with an easy motion. When you encounter a signal, identify the precise target position by
reducing the width of the sweep arc until it is just a few centimetres either side . . . Keep the search-
head moving.
rapid start
CS
4
PI
Содержание CS4PI
Страница 1: ...CS4PI operating instructions...
