C-SCOPE CS3MX, Руководство по эксплуатации

Страница: 8 / 16

4) Pin-point.
The ‘motion’ aspect of the CS3MX is switched off whilst the
pin-point button is depressed. In pin-point mode the search-head can be
held still to determine the precise target position. Pin-point mode
operates in ‘All Metal’, ie. whatever level of discrimination you have preset
will be switched off while the pin-point button is depressed.
This is a useful facility which allows you to trace around the edges of a
signal to identify large pieces of iron. (Note: very large pieces of iron, such
as discarded he detector is set to high discrimination settings).
5) Discrimination. Set to ‘0’ there is no discrimination, ie all metals are
detected. Set within the green area (1-4) on the scale signals from most
small iron rubbish are ignored, ie. there is no audio signal.
At higher settings (4-10) in the red area on the scale more classes of metal
likely to be rubbish are ignored. (see ‘Notes on Sensitivity, Ground Effect
and Discrimination’).
8
embling the CM3MX
The stem height adjuster should be slackened to allow the lower stem to enter
the upper stem section. The search-head lead may then be wound around
the stem as shown in the photograph. A search-head lead which is not well
secured to the stem could move about causing false signals. Cable ties or tape
may be used to hold the lead in position. There are slots in the lower stem
plastic section into which the lead can be fitted. When the search-head lead is
fitted correctly, the stem adjusting device can be tightened at a height suitable
for the user.