C-SCOPE CS3MX, Руководство по эксплуатации

Страница: 7 / 16

7
CS
3
MX
Follow these simple steps to start using the CS3MX within minutes . . .
1) Assemble the CS3MX by inserting the lower stem into the upper stem.
2) Rotate the lower stem so that the search-head cable is coiled around the
stem as shown in the photograph.
3) Twist the locking device so that the stem is locked into position at the
required length.
4) Remove the battery compartment cover by loosening the four retaining
screws.
5) Fit 8 x AA batteries to the battery holder being careful to observe polarity
and good contact.
6) Rotate the discrimination control to the green area on the scale.
7) Switch on and rotate the sensitivity control to the lower part of the green
area on the scale.
8) START DETECTING . . . metal targets give a sharp audio signal from
the loudspeaker . . . signals from small pieces of iron rubbish are ignored
. . . pressing the pin-point button means you can stop swinging the
search-head from side to side and identify the exact position of the target
1)
Control box mounting clip.
For ultimate lightweight metal detecting the
CS3MX control box can be removed and fitted to a belt around the body.
This leaves only the search-head on the stem which reduces fatigue
on the arm.
2) On/off/sensitivity. Rotary control switches the detector on/off and adjusts
the sensitivity. The area on the scale around the control marked in
green is the setting recommended for most ground conditions. Ground
containing mineralisation and some beach situations may cause instability
or false signals requiring a reduction of the sensitivity level.
3) Loudspeaker (and battery condition indicator). The presence of metal is
indicated by the increasing intensity of the loudspeaker tone. A distinct
step change in the pitch of the audio signal indicates that the batteries
should be changed.
rapid start
the controls and at they do