Description
Roller door remote control for use with 230V tubular motors up to 500W, compatible with GO and GO-MINI
transmitters, GO-BUTTON wireless push button, GO-SWITCH wireless keyswitch and GO-KEY wireless keypad
(push to run mode only).
Operating modes
Push to run open and close, or push to run open and hold to run close (deadman), see FIG's 1, 2 and 3 for DIP
switch and jumper J1 settings.
Photocells and safety edge
If a non-resistive safety edge or photocells are used a 8.2K resistor must be connected in series, see FIG 2, the
resistor can be found taped to the inside of the enclosure cover.
Autoclose
To turn on automatic closing switch DIP switch 1 to on, the default autoclose wait time is 45 seconds, to change
this see below.
Motor run time and autoclose wait time
The motor run time and autoclose wait times are set to 45 seconds by default, they can be set between 1 and
120 seconds. To change the times, ensure the door is fully closed, press the red programming button (PROG)
for 1 second, an audible signal will be heard, release the programming button, press the START button, the
door opens and the memorising of the motor run time is started. When the door is fully open press the START
button, the motor run time has been memorised and the autoclose wait timing has now started, when the
required time has passed press the START button, the autoclose wait time has been memorised, the control
unit exits programming mode.
Transmitter programming – Normal
The receiver can learn up to 15 different transmitter codes.
Press the red programming button (PROG) for 1 second, an audible signal will be heard, release the
programming button, the control unit is now in normal programming mode. Press the transmitter button that
you want to operate the door, an audible signal confirms the transmitter code has been memorised, repeat for
all transmitters. If 10 seconds pass without a transmitter being programmed the control unit will exit
programming mode.
In deadman mode (FIG 1) the 1st transmitter button opens and the 2nd closes the door.
In push to run mode (FIG 2 & 3) the transmitter button that has been programmed operates the door in step-
by-step mode, open - stop - close – stop.....
Transmitter programming - Open / Close
Only applicable when operating the control unit in push to run mode, FIG's 2 & 3.
Press the red programming button (PROG) an audible signal will be heard, keep pressed until the red PROG light
flashes and a second audible is heard, release the programming button, the control unit is now in open / close
programming mode. Press the 1
st
transmitter button, an audible signal confirms the transmitter code has been
memorised, repeat for all transmitters if 10 seconds pass without a transmitter being programmed, the control
unit exits programming mode.
In push to run mode (FIG 2 & 3) the 1st transmitter button opens and the 2nd closes the door.
Remotely programming transmitters
It is possible to program additional transmitters remotely.
Using an active transmitter, one that is already programmed, press both buttons (the buttons must both be
pressed at
exactly
the same time) the control unit will emit an audible signal and is now in programming mode,
press the transmitter button that you want to operate the door, an audible signal confirms the transmitter has
been memorised, if 10 seconds pass without a transmitter being programmed, the control unit exits
programming mode.
Memory reset, erasing all transmitter codes from the memory
Press and keep pressed the red programming button (PROG) for 10 seconds, 10 'beeps' will be heard followed
by a 2nd series of 'beeps' at a faster pace, the memory is now erased and the control unit is in programming
mode, if 10 seconds pass without a transmitter being programmed, the control unit exits programming mode.
