Quick Reference Guide
Page 2 of 12
15 MAR 2001 REV C
NAVIPILOT V HSC
N AV I G AT I O N A U TO M AT I O N
.
056300 8-151
Operation (contd.)
Select heading reference
3
Press to toggle between gyro/magnetic heading reference (in manual steering mode only).
Take over master control
4
Press to change unit's working mode from remote to master.
Clear rudder limit
7
Press to clear rudder limit, if set.
Display illumination
9
Press key. Display becomes brighter.
8
Press key. Display becomes darker.
Display test
89
Press and hold keys simultaneously. While keys are pressed, all display elements and the alarm buzzer
are activated.
Alarm system
When the autopilot detects an alarm state, an audible alarm is given and a corresponding message is displayed.
MAX. ROT EXCEEDED
rate of turn exceeds permitted max. value
OFF COURSE
difference between actual heading and set heading/course exceeds limit
G/M DIFF.
difference between gyrocompass heading and magnetic compass heading exceeds limit
POWER FAILURE
failure in power supply
FAILURE INTERF.
Hd6
Hd6
Hd6
Hd6
Hd6
no valid data at gyro- or magnetic compass interface
"
5Pd
5Pd
5Pd
5Pd
5Pd
"
speed interface
"
nAu
nAu
nAu
nAu
nAu
"
NAV-interface; Nav. receiver
"
1n5
1n5
1n5
1n5
1n5
"
NAV-interface; INS
Mute audible alarm
7
On alarm, press to mute alarm buzzer. Alarm status at ext. output will be cleared.
View error codes
89
On alarm, press and hold keys simultaneously to view error code. Note displayed code number and
press keys again to check for additional errors. Repeat until
888
is displayed (end of error code list).
Set autopilot parameters
Set steering parameters (enter mode)
6
Press to select enter mode. For enter mode operation, see page 3.
Set operating parameters (user setup)
67
Press keys simultaneously to enter user setup. For user setup operation, see page 4.
Set basic configuration parameters (service setup 1 and 2)
78
In manual steering mode, press keys simultaneously to access service setups.
For service setup operation, see pages 7 and 9.
