IP Camera Network Setup Guide
Phone: 800-252-1910
Int: 708-867-4002
3
of
10
Cautions:
⚫
Make sure the power supply voltage is correct before using the camera.
⚫
Do not drop the camera or subject it to physical shock.
⚫
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean
cloth with a bit of ethanol and wipe it gently. If the camera will not be used for an
extended period of time, put on the lens cap to protect the sensor from dirt.
⚫
Do not aim the camera lens at the strong light such as sun or incandescent lamp.
The strong light can cause fatal damage to the camera.
⚫
The sensor may be burned out by a laser beam, so when any laser equipment is
being used, make sure that the surface of the sensor not be exposed to the laser
beam.
⚫
Do not place the camera in extremely hot, cold temperatures (the operating
temperature should be between -30°C ~ 60°C), and do not expose it to high
electromagnetic radiation.
⚫
To avoid heat accumulation, good ventilation is required for a proper operating
environment.
⚫
Keep the camera away from water and any liquid during installation.
⚫
While shipping, the camera should be packed in its original packing.
Notes:
For the camera supports IR, you are required to pay attention to the following
precautions to prevent IR reflection:
⚫
Dust or grease on the dome cover will cause IR reflection. Please do not remove
the dome cover film until the installation is finished. If there is dust or grease on
the dome cover, clean the dome cover with clean soft cloth and isopropyl alcohol.
⚫
Make certain the installation location does not have reflective surfaces of objects
too close to the camera. The IR light from the camera may reflect back into the
lens causing reflection.
⚫
The foam ring around the lens must be seated flush against the inner surface of
the bubble to isolate the lens from the IR LEDS. Fasten the dome cover to camera
body so that the foam ring and the dome cover are attached seamlessly.