C-Fly Faith2 Pro, Руководство по эксплуатации, Страница: 76 / 84

Flight 72
Copyright 2022 C-Fly all rights reserved
Vertical calibration :
When the APP prompts to place the aircraft's head to be up and rotates, place the aircraft in
the hand and ensure that the aircraft body is perpendicular to the ground; then rotates the
aircraft horizontally. When the status indicator on the rear arm of the aircraft turns green (solid
or flashing), the compass is successfully calibrated, at this time, the APP will prompt 'calibration
successful', then tap 'finish' to end the calibration process, if the status indicator turns to solid
red light for about 6 seconds, the compass calibration fails. Please go to another location and
re-calibrate.
Note
：
●
After changing the flight site, make sure to calibrate the compass before the first flight.
●
If the aircraft indicator flashes blue and green alternately during flight, which means that the
compass is abnormal and need to calibrate.
●
Stay away from the environment with magnetic interference when calibrating, otherwise the
calibration may fail.
●
Do not calibrate in areas with strong magnetic fields, such as magnetic mines, parking lots,
and building areas with underground reinforcement.
●
Do not calibrate with carrying ferromagnetic materials such as keys, mobile phones, etc.
●
Do not calibrate when large pieces of metal are nearby.
6. Basic flight operation steps
1) Place the aircraft in a wide open area that its front is user's front.
2) Turn on the aircraft and remote controller.
3) Connect the remote controller with the aircraft and then proceed aircraft self-diagnostic
tests.
4) Connect the APP with mobile device and enter into the FPV interface.
5) Unlock the aircraft after the APP indicate: ready go.
6) Pull up the throttle stick then the aircraft takes off, and control the aircraft flight by left/right
stick.
7) Pull down the throttle stick to land the aircraft.
8) Down the throttle stick to the bottom position and keep for 3 seconds to lock the aircraft.
9) Pull out the battery from the aircraft and then turn off the remote controller.
7. Flight control instructions
1) Power on
Put the aircraft on the fat surface, turn on the remote controller and aircraft successively, wait
for aircraft on flat ground for about 30 seconds for self-diagnostic tests.
When the aircraft 's indicator light turns from flashing or solid blue to flashing or solid green,
EN
Vertical calibration