C. Davis Systems
CDS-LC
4.0
SYSTEM OPERATION
4.1
Pre-Start Check List
4.1.1 Verify there is a 110-120 VAC power source and an air
supply with a range of 100-120 PSI
4.1.2 The Contact Feeder Crimper is designed to accommodate
only the contacts, as noted in section 2.0. Any attempt to
use another type of contact will jam the Feeder mechanism.
4.2
Start-Up Procedures
Refer to drawing Below
4.2.1
Load specified contacts in the bowl (factory determined), by
opening the hinged access cover (item #1). Feed in the
contacts no higher than the lower lip near the bowl exit
(approximately 3/4" from top). Overfilling will jam the bowl.
4.2.2
Connect the Air Supply (100 - 120 PSI) at the back of the
machine (item #5).
4.2.6
Check air pressure to the machine to make sure it is correct.
Model #CDS-LC C. Davis Systems Inc. Operations Manual
