C & K Systems S5010, Инструкция по использованию

Страница: 21 / 72

2
User Codes
17
Relay
Code
Standard Code ___
Optional Code _X_
Active Certain Days/Times ___
If an intruder forces you to dis-
arm your system, this optional
code sends a silent signal to
alert monitoring station person-
nel that you are in danger.
For systems without multiple
areas, the code is assigned to
user number 15. You can
change or delete this code like
any other user code.
Standard Code ___
Optional Code _X_
Active Certain Days/Times _X_
Duress
Code
A relay code acts like a switch. When you enter this code, a device
that is connected to the control panel is turned on or off. For ex-
ample, your system can be programmed to switch the exterior lights
of your building on or off when you enter a relay code. Relay codes
must be programmed into your system by the installer.
The relay code is a four-digit code that you can change or delete like
any other user code. If you delete the relay code, you will no longer
be able to use this feature. For systems without multiple areas (as
described in Section 7), the code is assigned to user number 14.
To Use the Duress Code:
1. Enter the four-digit code.
You see:
READY
Your system appears to dis-
arm normally. However, a
message is sent to your
monitoring station that you
are in danger.