BZBGEAR BG-EXH-100C5
PRODUCT MANUAL
Operation Controls and Functions
Transmitter Panel
Name
Function Description
Power LED
The red LED will illuminate when the transmitter is on. The LED will be off when the transmitter is
on standby.
ARC LED
The green LED will illuminate when the ARC function is turned on.
SPIDIF LED
The green LED will illuminate when the SPDIF OUT port outputs the audio signal that is returned
from SPDIF IN of the receiver.
SWITCH
Press the button to switch the output audio signal source for the SPDIF OUT and L/R OUT port.
SERVICE port
Firmware update port.
DC 24V
DC 24V input for 24V 1A power adapter.
Note:
The extender supports PoC functionality. Either the transmitter or receiver must be
connected to a 24V/1A power supply. The other does not require a power supply.
HDBT OUT
RJ45 port to connect to the HDBT IN port of the receiver using a CAT 6/6a cable.
Connection Signal
Indicator lamp
Solid: The transmitter and receiver have a good connection status.
Flashing: The transmitter and receiver have a poor connection status.
Dark: The transmitter and receiver are not connected.
Data Signal
Indicator lamp
Solid: HDMI signal with HDCP.
Flash: HDMI signal without HDCP.
Dark: No HDMI signal.
HDMI IN
HDMI source input.
IR IN
IR input port to receive the IR remote’s signal.
IR OUT
IR output port for source device control. This IR output signal is from the IR IN port of the
receiver.
L/R OUT
3.5mm stereo connector for analog audio output.
SPDIF OUT
SPDIF connector for optical audio output.
RS-232
3-pin Phoenix connector for RS-232 command transmission. The RS-232 command will
pass-through from transmitter to receiver or receiver to transmitter.
LAN
RJ45 connector for connecting Hub or router.
Address:
830 National Drive #140, Sacramento, CA 95834, USA
·
Tel:
+1(888)499-9906
·
Email:
8
