BZBGEAR BG-UDA-E18
PRODUCT MANUAL
Operation Controls and Functions
Transmitter
Front Panel
NO.
Name
Function Description
1
POWER LED
When the device is powered on, the red power LED will be on.
2
IN LED
When the HDMI IN port connects an active source device, the green LED will be on.
3
LOOP LED
When the HDMI LOOP OUT port connects an active display device, the green LED will
be on.
4
OUT(1~8) LED
When the HDBT OUTPUT port connects an HDBaseT Receiver, the corresponding green
OUT LED will be on.
Rear Panel
No. Name
Function Description
1
EDID DIP switch
Used to set EDID mode. Please refer to Section “6. EDID Mode” for details.
2
RS-232
Connect to a PC or control system via a 3-pin phoenix connector cable for three
functions:
1. Firmware update;
2. Control the Splitter via RS-232 commands;
3. RS-232 signal pass-through (from transmitter to receiver or from receiver to
transmitter).
3
IR IN
Connect to IR receiver cable, the IR receive signal will emit to “IR OUT" port of the
HDBaseT Receiver.
4
IR OUT
Connect to IR blaster cable, the IR emit signal is from “IR IN” port of the HDBaseT
Receiver.
5
AUDIO OUT (COAX, L/R)
Coaxial/balanced audio output port, connect to amplifier or speaker.
6
HDMI port
●
IN
: HDMI input port, connect to HDMI source device such as DVD or set-top box
with an HDMI cable.
●
LOOP OUT
: HDMI loop output port, connect to the HDMI display device such as TV
or Monitor with an HDMI cable
7
HDBT OUTPUT port (1-8)
Connect to the HDBT IN port of the HDBaseT receiver with a CAT cable.
8
DC 24V
Plug the DC 24V power supply into the unit and connect the adaptor to an AC outlet.
(
Note
: The transmitter can power the receiver via a CAT cable.)
9
POWER switch
Press this switch to power on/off the device.
Address:
830 National Drive #140, Sacramento, CA 95834, USA
·
Tel:
+1(888)499-9906
·
Email:
7
