Put in 6x "AA" 1.5 V batteries
battery
1.5V
1.5V battery
1.5V battery
1.5Vbattery
1.5V battery
1.5 V battery
Back Cover
DC Jack
Cable Water resistant
plug
Cork up the DC jack for effective water
resistant
Plug the DC Jack
p6.
2: Battery Operation:
Insert 6 x "AA" Batteries (LR6), making sure the polarity is correct as the internal markings.
3: Main Power.
Using the back plate as a template, drill an additional hole to feed the DC jack connect of the plug-in
adapter. Feed the DC jack connector through the wall and the back of the back plate making sure that
the connector goes through the rubber grommet as shown in the diagram. Plug the plug-in adapter into
a standard 13amp 230-240V 50Hz socket.
Plug the jack connector into the chime as shown in the diagram.
4: place the front camera section into the base plate and screw the ant-theft screws into the back plate.
p7.
1
2
3
4
7
6
8
9
10
11
5
ff
O/n
O r
ew
oP
NI
C
D
L
O
V /
U
N
E
M
Installation: Wireless Video Receiver
1. Menu/VOL. Control
2. Power ON/OFF
3. CH Select (1/2/3)
4. DC Power Jack
5. Antenna
6. Power On (Green)
7. Monitor Batt low (Red)
8. Stolen Buzz Alarm (Orange)
9. Outdoor unit Batt low(Red)
10. Power LED Stand by (Blue)
11. Power Adaptor Plug
12. Buzzer
Avoid locating the Video receiver on metallic or reinforced concert surfaces and away from metal
shelving, mirrors, microwave ovens and wire free networks (WiFi) as with will reduce the operating
distance.
Remove the battery cover from the back of the wireless video receiver
and insert 4x "AAA" Batteries(LR03). The video receiver can also be
main powered, insert the jack plug into the side of the unit as shown
in the diagram and plug the plug-in adapter in to a 13amp 230-240V
50Hz socket.
MENU/ VOL
+ "AAA" 1.5V -
+ "AAA" 1.5V -
- "AAA" 1.5V +
- "AAA" 1.5V +
The wireless receiver is now ready to be used.
To switch the wireless video receiver on, press the On/Off button on
the right hand side of the unit, the blue LED will flash to indicate that the unit is on.
When the bell push is pressed on the video bell push, the handheld video receiver will make and an
alert sound and display the video and audio from video bell push, allowing you to see and hear who
is at the door.
Video display setting:
To alter the display setting on the handheld video receiver, push the menu button
inwards to display and the select the required adjustment.
Then use the up/down to adjust the required setting.
Volume select:
Use the up/down to select the required volume level.
12
BRIGHTNESS
CONTRAST
SHARPNESS
COLOR
HUE
VIDEO
50
