POSSIBLE MOUNTING POSITIONS
INSTALLATION INSTRUCTIONS
SPA COVER
SPA SKIRT
DECK OR FLOOR MOUNT ONLY - SIDE VIEW
STEP 1
The spa cover must be in the closed position prior to mounting the
Ultralift. Position the spa cover properly, ensuring it is sitting
squarely on the spa. Assemble the undermount bracket using two
of the 5/16” ny-lock nuts, as shown in the Illustration.
STEP 2
Working with an empty tub or spa, slide assembled
undermount bracket under the spa skirt, close to the end of
the hot tub on both sides. A minimum of 16” between the rear
wall of the spa and any wall or fence is needed to accommodate the
undermount position. To prevent splitting of the wood skirt we
recommend pre-drilling the holes with a 1/16” drill bit.
STEP 3
Connect the square slider arm between two pivot brackets by
threading two 2” long bolts through the pivot bracket, square slider
arm and second pivot bracket at the two holes indicated by “A”.
Tighten with four 3/8” hex nuts from the side closest to the spa.
Attach the round side pivot arm between the same two pivot
brackets, using the holes identified as “B”, by feeding one 2” long
bolt threaded through the bracket, through the round pivot arm,
and through the other bracket, and secure using a 3/8” ny-lock nut.
DO NOT OVER TIGHTEN HERE, as the pivot arm must be able to
move freely. Repeat assembly of the square slider arm, the pivot
brackets and the round side pivot arm on the other side of the spa.
Slide the square slider arm into the mounting bracket on each side
of the spa.
ILLUSTRATION FOR STEP 3
ASSEMBLY OF SLIDER ARM TO PIVOT ARM - SIDE VIEW
PIVOT BRACKET
SQUARE SLIDER ARM
MOUNTING BRACKET
(ROTATE DEPENDING ON CHOSEN MOUNT)
A
B
UNDERMOUNT BRACKET ASSEMBLY x 2
(DECK OR FLOOR MOUNT ONLY)
(5/16” NY-LOCK NUTS)
