POSSIBLE MOUNTING POSITIONS
INSTALLATION INSTRUCTIONS
STEP 4
Insert the corner support arms into the center pole. After
positioning the center pole so that an equal space is on each
side of the spa, slide the corner arms into the pivot arms.
STEP 5
Allow the
Ultralift
to rest on the spa cover. Make sure the
center pole is in the middle of the spa cover and adjust the
corner support arms so that the center pole is situated
parallel to the spa cover allowing between 1/2 inch and 1
inch of space from the center. Attach the center pole to
the corner support arms using six of the #10 - 5/8” self
tapping screws. Pre-drilling through the corner support
arms is advised. We recommend rotating the center pole
so that the screws are inserted horizontally.
STEP 6
Position the slider arm so that the lifter extends an equal
distance and sits squarely behind the spa. We recommend
you attach the slider arm to the mounting bracket by
inserting one #10 - 5/8” screw on each side and then
opening the cover and testing the position of the fully
open cover. Once the desired position is reached insert
three more of the #10 - 5/8” screws into each mounting
bracket. Similarly, once the lifter is adjusted to fit, secure
the corner support arm in the round side pivot arm with 3
screws. insert the two round plastic caps into the open
end of the pivot arms, the square caps into the open end
of the slider arm, and cap all screws and bolts. that's it,
you're finished.
NOTE:
The hook pin should be inserted into the pivot
bracket when the spa cover is opened, for added safety,
and removed to close the cover.
ILLUSTRATION FOR STEPS 4 & 5
ASSEMBLY OF CORNER ARMS TO PIVOT ARMS - FRONT VIEW
CORNER
SUPPORT
ARM
CORNER
SUPPORT
ARM
CENTER POLE
SPA COVER
SPA SKIRT
CAUTION:
DO NOT USE
The Ultralift in
extreme wind
conditions. The spa cover may blow
over and impact the spa user.
SPA SKIRT
UNDERMOUNT - SIDE VIEW
