BYE BIKE ONE&ONE, Руководство пользователя

Страница: 51 / 64

WARNING
Electrolyte is poisonous and dan-
gerous since it contains sulphuric
acid, which causes severe burns.
Avoid any contact with skin, eyes or
clothing and always shield your eyes
when working near batteries.
In case of external contact: flush with
plenty of water.
In case of ingestion: drink large
quantities of water or milk and imme-
diately call a doctor.
In case of contact with eyes: flush
with water for 15 minutes and seek
prompt medical attention.
WARNING
Batteries produce explosive hydro-
gen gas. Therefore, keep sparks,
flames, cigarettes, etc., away from the
battery and provide sufficient ventila-
tion when charging it in an enclosed
space.
Storing the battery
1. If the vehicle will not be used for more
than one month, remove the battery, fully
charge it, and then place it in a cool, dry
place.
2. If the battery will be stored for more
than two months, check the specific gravity
of the electrolyte at least once a month and
fully charge the battery whenever neces
-
sary.
3. Fully charge the battery before instal -
lation.
4. After installation, make sure that the
battery leads are properly connected to
the battery terminals and that the breather
hose is properly routed, in good condition,
and not obstructed.
CAUTION
When removing the battery, be sure
the key is turned to “OFF”, then
disconnect the negative lead before
disconnecting the positive lead.
CAUTION
Vehicle could suffer structural and
external damages if is exposed to
electrolyte or gas, expelled from the
battery.
51
Maint
enance
6.17 Fuse
Fuses protect the electrical circuits on
your vehicle. If something electrical on your
vehicle stops working, check the fuse and
replace it if necessary.
1 2
1. Fuse in good condition. 2. Blown fuse.
Replacing the fuse
The fuse holder is located besides the
battery. Remove engine compartment top
panel to access the fuse. If the fuse is
blown, replace it as follows:
1. Turn the key to "OFF" and turn off all
electrical circuits.
2. Remove the blown fuse, and then in -
stall a new fuse of the specified amperage.