BWT PERMAQ PRO 1810, Инструкция по установке и эксплуатации

Страница: 4 / 32

EN
4
1. GENERAL
INFORMATION
This installation and operating
manual applies to BWT
PERMAQ ® Pro 1800 total desal-
ination plant.
This
installation and operating
manual contains important
information about the correct
installation and operation of the
BWT Pro 1800 plant.
1. Enclosed “Start-up test”-
(section 13.4) shall be
completed and filed to-
gether with the operat-
ing journal.
2. Operating journal shall
be updated as described
in “Operating journal”
(section 13.5).
3. Floor drain must be
available in the immedi-
ate vicinity of the plant.
4. The BWT PERMAQ
®
Pro
1800 plant removes
more than 99 % of all
salts, and that is why
you need to be alert to
possible post-treatment
with mixed bed or simi-
lar, if a better water
quality is requested.
5. The authorised agent
takes on full responsibil-
ity without costs for BWT
who, however, grants a
12 months guarantee in-
clusive of replacement of
defective spare parts, on
condition that the parts
are returned to BWT
along with a specifica-
tion of the fault and stat-
ing production month/
year (plant no.).
6. The warranty becomes
invalid, if the plant is not
commissioned by an au-
thorised BWT service
technician.
7. The warranty becomes
invalid, if maintenance
intervals are not met.
Your BWT PERMAQ® Pro 1800
plant is constructed in a com-
pact design with reservoir (op-
tion) and softening unit (option)
installed externally so that the
plant takes up as little space as
possible and can be installed in
the most suitable way.
This instruction should be read
carefully before installing and
starting up the plant. Correct
installation and operation will
also form the basis of a factory
warranty.
The BWT PERMAQ® Pro 1800
plant with its compact and fin-
ished design is easy to install,
since all installations are pre-
assembled and tested in our
factory.
Your BWT PERMAQ
®
Pro 1800
plant is designed for a minimum
of service and for long and
unproblematic operation. How-
ever, this is on condition of
correct installation and mainte-
nance.
Always read this manual care-
fully before commissioning.
2. EXPLANATION OF
WORDS
There will be a few technical
explanations in this instruction
which we explain below.
Permeate: The treated, totally
desalinated water
which is produced
by
the BWT
PERMAQ ® Pro
1800
plant and supplied
to the reservoir
tank.
Concentrate: Is the water that is
led to outlet. This
water contains the
salts and minerals
that have been
removed from the
water.
Feed water: Is the water which
is led directly to
the
BWT
PERMAQ
®
Pro
1800 plant and
which must be de-
salinated in the
BWT
PERMAQ
®
Pro 1800 plant.
TDS: The amount of
totally dissolved
salts, measured in
(mg/l).
Conductivity: Is the designation
of salt concentra-
tion of the water,
measured
in
(µS/cm). The low-
er the value, the
better the water
quality.
Membranes: Is the filter of the
plant which by
high pressure and
flow is capable of
desalinating
the
feed water.
RO: The abbreviation
for Reverse Osmo-
sis.
Transport- Is the pump which
pump: transports the
treated water from
the plant reservoir
to the consumer.
Level switch: Is a switch, which
gives
a signal
when the BWT
PERMAQ
® Pro
1800 plant must
either be started or
stopped, and it
stops the transport
pump in case of
dry-running of the
reservoir tank.