BWT BWTDWFK-TRIFLO, Руководство пользователя

Страница: 6 / 8

0
8: Installing the Cartridge
Remove the cellophane shrink-wrap and hygiene cap from
cartridge [13]. Before installing the filter cartridge, mark the
installation date and the replacement date (no later than 6
months) in the space provided on the filter’s label. Hold
cartridge near the bottom when installing or changing the
cartridge. Push the cartridge into the filter head [14] and
the same time rotate anticlockwise when viewed from
above. Installation can be simplified by turning the filter
head in the filter bracket by 90° where space permits.
09: Bleeding the system
- Please close all taps .
Open the filter water tap [1] fully to allow for continuous
flow, then slowly turn on the water supply allowing water to
enter the filter slowly and displace trapped air and loose
particles.
(
Please check installation carefully for leaks.
)
Allow water to flow through the system for around 5
minutes or until water runs clear and bubble free
(Minimum 5 litres). Repeat flushing process whenever the
filter is left unused for a prolonged period of time. Always
flush drinking water filter system for 10 seconds before use.
Now ensure the hot and cold water taps are free from air by
opening each slowly and closing them again when the
water runs clear and bubble free
.
10: Setting the bypass
Your BWT filter head [14] is fitted with a 4 position bypass
valve that can be used to allow filtered water to be mixed
with incoming water from the mains for specialist
applications.
For domestic drinking water applications the
By-Passshould be set according to the table below .
<RXFDQFRQWDFW\RXUORFDOZDWHUVXSSO\FRPSDQ\WRREWDLQ
WKHZDWHUKDUGQHVVLQ\RXUDUHD
11: Replacing the filter cartridge
Turn off the water supply at the water supply valve before
starting work. Unscrew the filter cartridge [13] out of the
filter head [14] in a clockwise motion dismantling can be
simplified by turning the filter head in the filter bracket by
up to 90° where space permits
Install new filter cartridge [13] as described in Section 9.
Flush and bleed filter cartridge as outlined in Section 10.
Dispose of the removed filter cartridge; observe the local
disposal regulations.
14
8
Your BWT Filter can be changed
without isolating the water supply
however turning off the water at
the stop cock or other suitable
isolation valve can help prevent
unnecessary water spills.
11
1RWH5HSODFHPHQWILOWHUVDUHXVXDOO\DYDLODEOHLQWKHVWRUH
ZKHUH\RXERXJKW\RXU%:7)LOWHU6\VWHP,QFDVHRI
GLIILFXOW\REWDLQLQJDUHSODFHPHQWILOWHUSOHDVHFDOORXU
FXVWRPHUVHUYLFHWHDPRQ
0
8
17