ATTACHING
YOUR LINES
8. Unroll your lines off your bar making sure there are no
twists
9. Make sure the bridle of the kite is not tangled. Place
your kite on its leading edge and connect the center lines
to the front bridle attachment points.
10. Connect the red and black outside lines to the rear
attachment points. Make sure the red fly line is connected
to the red attachment point and the black fly line is
connected to the black attachment point.
11. Connect safety leash from your harness to the off
switch ring. Ensure the safety quick release is positioned
close to your harness.
**Safety Leash
If you need to activate the quick release on the
safety leash simply grab the tubing section and
pull in the direction of the arrow.
Make sure the release handle is within reach
when attaching it to your harness. We do not
recommend hooking the leash to your back.
Safety Leash Reset
• Insert the metal safety pin through the loop
in the rope end.
• Fold the stainless steel ring over the loop and
secure the end by pulling the plastic tubing of
the red safety handle over the QR pin until it
rests securely against the plastic ball.
• Double check that your Safety leash is seated
properly by pulling to the outside of the red
handle on both sides.
Attach lines as shown.
Red - rear (outer)
Black - front (centre)
Connect safety
leash to off-
switch ring
and harness as
shown.
9. Connect the
lines as shown.
