PRODUCT INFORMATION
BULLETIN
238 Pillow Street
Butler, PA 16001
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
AIR-EAGLE
®
SR PLUS
2.4 GHz RF Transmitter
MODEL 36-1420-2B-120VAC –
Rev.3
DESCRIPTION
The A
IR
-E
AGLE
SR PLUS,
MODEL
36-1420-2B
I
s an R.F. transmitter
capable of sending up to two digital button commands to the Air-Eagle
SR Receiver, model 38-5000, 38-5050 or 38-8000 from up to 1200 feet
away. This unit has a convenient thumbwheel switch on the front panel
allowing the user to select one of 100 digital addresses. It also has
eight user-programmable network frequencies to allow multiple
transmitters and receivers to operate simultaneously in the same area
without interference.
INSTALLATION
1.
Mount the A
IR
-E
AGLE
SR PLUS TRANSMITTER in a convenient
location where the operator will have easy access to all buttons.
2.
Install antenna. The unit has an antenna connector located on the
right side on the enclosure. Attach either the supplied portable
antenna or external antenna’s coax cable to this connector.
3.
Connect AC power and control to the proper terminals in your control
circuit.
DIGITAL ADDRESS & FREQUENCY SET-UP
This transmitter is factory programmed to Frequency #1 and Digital
Address “0”. These settings can be changed by the user in any
combination
but must match the receiver that is set up to
communicate with this transmitter
.
Thumbwheel
Switch
0 thru 99 for selecting any one of 100 digital
addresses.
To Change Network Frequency:
1)
Remove top cover.
2)
Select desired network frequency
3)
Move SW4 on SEL2 to the “CLOSED” position. The TX LED will
illuminate (no data is being transmitted during this programming)
4)
Once LED is illuminated, move SW4 on SEL2 back to the
“OPEN” position. The TX LED will extinguish.
5)
Programming is now complete. Replace top cover.
Note – Selected address and frequency settings will be maintained, in
the internal flash memory, even if power is removed from unit. The
above procedure needs to be performed only if
changing
network
frequency)
Network
Address
SW1
SW2
SW3
1
OPEN
OPEN
OPEN
2
CLOSED
OPEN
OPEN
3
OPEN
CLOSED
OPEN
4
CLOSED
CLOSED
OPEN
5
OPEN
OPEN
CLOSED
6
CLOSED
OPEN
CLOSED
7
OPEN
CLOSED
CLOSED
SEL 2 (SW 1-3):
(NETWORK
FREQUENCY)
8
CLOSED
CLOSED
CLOSED
Normal Operation
Programming
SEL2 (SW4)
OPEN
CLOSED
Dimensions (with mounting plate) 6.3” L x 4.8” W x 2.3” H
CONTROLS & INDICATORS
POWER/TX LED
Illuminates GREEN while power is applied.
While any button is depressed and unit is
transmitting, this LED will change to RED.
Pushbuttons 1 and 2
Transmits individual button RF codes to the
receiver
Thumbwheel Switch
Used to change digital address of transmitter
APPROVALS
United States (FCC)
OUR-XBEEPRO
Canada (IC)
4214A-XBEEPRO
Europe (CE)
ETSI
