BVM Yak 130, Инструкция по монтажу и эксплуатации

Страница: 34 / 58

YAK 130
BVM ©2016 33 Mar. 23, 2016
NOTE: This set-up requires the Cockpit Tub to
be removed for fueling and starting engine.
See Alternative System on following Page.
 At BVM, we like to run the engine with the
System Analyzer/GSU always handy. The
advantage of this is that you can always
access the internal diagnostics when
needed. We located ours on top of the main
tank using Velcro for quick access.
Observing the numbers (especially the
E.G.T.) during start-up is a good safety
practice.
 Install the fuel filter in a vertical
position on the fuse wall. Route
the fuel line from the fuel pump
to the filter.
 From the filter, install the on/off
valve in the area aft of the “O”
clip prior to exiting the forward
fuse area. Use the “O” clip to
secure the fuel tubing in place.
Exit aft to the cockpit area
through the same location as
the servo wires and route

Use a small “O” clip on top of the Inlet to
route and secure the Turbine Fuel, Power,
and ECU cables and plug them into their
respected locations.