Ultra Bandit EVO
Assembly & Operation Manual
BVM ® 2019
18
11/12/2019
Control Surface Deflections and Expo Settings
Note:
The BVM Demo plane is set up using the following Expo percentages. Positive
values are used on Spektrum and JR radios, Futaba uses negative.
Control
High Rate Travels
Expo
D/R M
D/R L
Stab (measured at the fuse side.)
Up 1
”
Down .75
”
25
80%/25
50%/20
Aileron (measured at the Flap)
1.0”
1.0”
25
80%/25
50%/20
Flaps (measured at the Root)
Take Off 3/4”
Landing
Rudder (measured at the Bot.)
L&R 1.25
”
25
80%/25
50%/20
Connecting RX wires
The wires are labeled from the factory. If you are using the DX18, the program is available
on a SD card from BVM. Follow the chart below to connect the servos.
DX18 Connection Chart
RX Port
(1)Throttle
(2)Aileron
(3)Elevator
(4)Rudder
(5)Gear
(6)Aux1
Surface
Throttle
Right Ail
Right Elev
Rudder
Left Flap
Left Ail
RX Port
(7)Aux2
(8)Aux3
(9)Aux4
(10)Aux5
(11)Aux6
(12)Aux7
Surface
Right Flap
Gear
Left Elev
Brake
Nose Steering
Gyro
DX18 and DX18QQ Transmitter File
The BVM Demo models are setup on Spektrum DX18 transmitters. The file included on the
SD card has all the mixes, rates, expos, and settings done for you. Setting the sub trim
and travel adjustment must be accomplished by the modeler for the specific aircraft.
Important!!! Check the directions of all flight controls before each flight.
Switch/Lever/Trimmer Channel
Output
Switch A
(8)Aux 3 Gear
Landing Gear, Down is Down
Switch D (Flight Modes)
Flaps
Up is Normal flight
Mid Take Off
Down is Landing
Switch E
Brakes
Pos 0-off, Pos 1-pulse, Pos 2-stop
L. Trim
Steering Trim/(11)Aux 6
Down for Right Steering Trim
Up for Left Steering Trim
Switch F
Aileron Rates
Up (0) is High
Switch G
Gyro
Pos 0- off, Pos 1- low, Pos 2- high
Switch A
Timer
