BVM Go Fly Gold F-18C, Сборка и руководство по эксплуатации, Страница: 32 / 34

BVM ®2021 31 10/2021
Connecting RX wires
The wires are labeled from the factory. If you are using the DX18, the program is available on
a SD card from BVM. Follow the chart below to connect the servos.
DX18-20 Connection Chart
RX Port Throttle Aileron Elevator Rudder CH 5 Aux1
Surface Throttle Right Ail
(Ail 2) Right Elev
(Elev 2) Rudder
Right Left Flap Left Ail
(Ail 1)
RX Port Aux2 Aux3 Aux4 Aux5 Aux6 Aux7
Surface Right
Flap Left
Rudder Left Elev
(Elev 1) Gyro Canopy Nose Wheel
RX Port X-1 X-2 X-3 X-4 X-5 X-6
Surface Leave
Open Leave
Open Smoke Lights Speed
Brake Gear
RX Port X-7 X-8
Surface Brakes
DX18, DX18QQ, DX 20 Transmitter File
The BVM Demo models are setup on Spektrum DX18 transmitters. The file included on the
SD card has all the mixes, rates, expos, and settings done for you. Setting the sub trim and
travel adjustment must be accomplished by the modeler for the specific aircraft.
Important!!! Check the directions of all flight controls before each flight.
Switch/Lever/Trimmer Channel Output
Switch A X+6/Gear Flight Timer (0) Gear Down
(1) Gear Up/ Timer Starts
Switch B X+4/ (0) Lights Off
(1) Nav Lights On
(2) Nav and Landing Lights On
Switch C X+3 Smoke (0) Off
(1) Medium
(2) Full
Switch D Flaps Chanel 5/ Aux 2 (0) is Normal flight
(1) is Flaps Take Off w/ up elevator mix
(2) is Flaps Landing w/ up elevator mix
I
L. Trim Steering Trim/Aux 7 Down for Right Steering Trim
Up for Left Steering Trim
Switch F Aileron Rates Up (0) is High
Switch G Gyro Aux 5 (0) Off
(1) Mid Rate 50%
(2) High Rate 60%
R Knob Aux 6 Canopy Left Open/ Right Closed
Right Lever X+5 Speed Brake Up/Away
– Brake Closed
Down/Pulled
– Brake Open
Switch E X+7 Brakes (0) Brakes Off
(1) Brakes Mid/ Pulsing
(2) Brakes Full Stop