BVA Hydraulics HNS105, Руководство по эксплуатации

Страница: 5 / 20

5
1. Unscrew the chisel holder from the cylinder.
2. Place the knobbed end of the cutting chisel into the center hold of the chisel holder.
3. Insert the set screw into the threaded side hole of the chisel holder. Do not over
tighten the set screw, it is provided to hold the cutting chisel inside the chisel holder
only. The cutting chisel should be loose enough to spin with minimal friction inside the
chisel holder, but not fall out.
4. Place the appropriate space for the nut you are cutting inside the cylinder. The spacer
shall be placed inside the cylinder in such a way that engraved side can be read.
Only one spacer is required to split a nut. Never split a nut with more than one spacer
installed at a time, doing so will damage the stud threads.
5. Screw the chisel holder and chisel assembly (from step 3) into the cylinder until it is
seated firmly and bottomed out in the cylinder.
6. Connect the cylinder and pump together via 10,000 PSI hydraulic hose.
7. Pressure up the cylinder until the internal piston has been fully extended from the
cylinder. Hold the pressure so that the piston stays in this extended positon.
8. Place the BVA Nut Splitter housing on the threaded end of the cylinder and screw the
housing onto the cylinder. Screw the housing all the way onto the cylinder until it is
seated firmly and bottomed out on the cylinder, unscrew the housing one full turn.
9. Insert the set screw into the threaded side hole of the housing and tighten to secure it
into place.
10. Release the held pressure on the cylinder to allow the piston to retract back into the
cylinder.
11. Your BVA Nut Splitter is now fully assembled and ready for use.
Section 1- Assembly Instructions for
"Type 1" Chisel Holders.
SFA Companies
10939 N. Pomona Ave. Kansas City, MO 64153
Tel: 888-332-6419
E-mail: sales@bvahydraulics.com