Buzz Rack BUZZPRO P10, Инструкция по эксплуатации

Страница: 12 / 16

01.Please make sure you clean the surface of the towball completely before installing the rack
02.Always use safety straps provided to secure the load
03.Always check that load is evenly distributed on the platform
04.The user is responsible for periodically verifying that all hardware, straps, knobs, hubs are securely tightened for
safety purposes.
05.You might have to use more webbings to secure your loading.
06.Do not open the gate with the platform installed on the carrier.
07.The locks used on this rack are theft deterrent.
08.Before leaving and at every stop, please check that all the parts and cargo are firmly tightened.
01.If the carrier obstructs the vehicle's tail lights and license plate, you must use an additional signal board.
02. The rack increases the vehicle’s length and weight. Be aware of this when passing through narrow or low clearance
spaces and when reversing. Any loads exceeding the indicated dimensions must nevertheless respect existing regulations
and be properly strapped down.
03.The load on the rack will affect driving. Do not exceed the speed limit, and do not drive faster than 120 km/h (75 mph).
04.Drive slowly over speed bumps. Respect the speed limit, and adapt your speed to the condition of the road.
05.Off-road driving is not recommended and could result in damage to your vehicle, hitch receiver, platform, or your load.
06.If you hit a bump or a hole in the road, stop your vehicle and inspect the load and the carrier. If you notice anything wrong,
remove the load and do not use the carrier.
07.Make sure there is a safe distance between the load and the ground, especially when entering a driveway.
WARNINGS
SAFE AND PROPER USE
ROAD SAFETY
12
!
EN
01.Please read and observe the instructions carefully before you use the product, and keep them in a safe place for future use.
Check the part list after opening the package. Make sure that all the parts are fully assembled according to the instruction
before fitting it on your car.
02.The user is responsible for assembly and installation of this product, and the manufacturer disclaims any liability due to i
mproper fitting or use of the product.
03.Failure to properly install the product and/or heavy loading may cause damage to the vehicle and/or the objects, and may
result in personal injury.
04.Do not use this product for purposes other than those for which it is designed. Do not modify any components of the
product. Remove the carrier if not in use.
05.Do not use the carrier to carry more weight than recommended in the chart in page one of the manual. Total weight
limitation (pl load) depends on the tow ball capacity "S" given by manufacturer.
06.Fits 50mm ISO tow balls. Always check the weight limitation of your towing system and never overload it.
07.Do not install the product on trailers, campers, or RVs.
GENERAL REMARKS
01.Periodically inspect the product for signs of wear, corrosion, and fatigue.
02.Do not use the carrier with defective parts, contact the dealer to replace them before using it again.
03.Remove the product before entering an automatic car wash.
04.To keep your product in the best condition, it is recommended to remove the product from the car when not in use.
Please be advised that this product is not designed to resist extreme weather conditions, especially seacoast air.
05.Lubricate the bolts in order to avoid corrosion.
MAINTAINING YOUR BICYCLE RACK