3
TM
IMPORTANT! Make sure all wires securely attached to
vehicle or spreader. Use wire ties and/or wire clamps to
attach wires. All excess wires must be rolled into bungles
and attached to vehicle or spreader.
E.
Connect the 2-pin connector on the power cable to the
control box mating connector.
F.
Connect wire harness single connectors to control box
connectors.
G.
Connect fuse connector to the fuse terminal or ignition
switch (5 AMP max).
H.
Lay out a path for the power cable to the battery, use quick
ties to secure power cable.
DO NOT CONNECT TO BATTERY AT THIS TIME!
I.
Lay out path for wire harness to the rear of the vehicle. It
is recommended to stay clear of the exhaust system. Excess
heat can damage the wire harnesses. Use quick ties to secure
harness to underbody.
J.
Connect the wire harness to the motors and vibrator. Make
sure wire colors on wire harness match colors on the motor.
Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion.
DO NOT CONNECT WIRE HARNESS TO DAMAGED
OR CORRODED TERMINALS! IT MAY RESULT IN
OVERHEATING, LOST POWER AND POTENTIAL
CONTROLLER DAMAGE!
K.
Install the circuit breaker within 12" from the battery. Connect
red wire from cable 3035935 and battery cable 3001379 to
circuit breaker according to the breaker markings. Connect
the power cable and battery cable directly to the battery.
Make sure connection to battery terminals is good and tight.
Loose connection to battery terminals will result in sparking,
overheating and possible battery damage!
In trucks with dual battery systems always connect power cable
to primary battery (larger capacity/ truck starting battery).
L.
Insure all functions of the controller are working properly.
M.
Observe chain moving in proper direction. If direction is
wrong reverse wires between Motor and Wire Harness.
N.
Optional spot light (5 AMP max) can be installed on spreader.
Use utility light kit part number 3018009. Remove cap from
single white wire. Connect light to this wire and the trucks
frames known ground (negative).and trucks frame.
3. CONTROLLER OPERATION
A
. SHPE6000CH is equipped with a dual independent speed
controller. To start spreader, press "POWER" switch. Switch will
be illuminated. Chain and spinner will start rotating full speed for
2-3 sec then will slow down to originally dialed speeds. Chain
and spinner can be adjusted independently.
3016934
3016944
0203700
3035935
CB150PB
3001379
BATTERY POSITIVE
BATTERY NEGATIVE
CONNECT TO FUSE
OR WIRE IN FUSE PANEL,
CONTROLLED BY
IGNITION SWITCH
