9
4. Insert 1/4” diameter shank of a Grinding Accessory (not included) fully
into Collet Nut. Then, firmly re-tighten Collet Nut to lock both the Collet
and Grinding Accessory in place.
5. Connect air supply hose to Air Inlet. Turn on air compressor and set its
regulator to the maximum 90 PSI for Die Grinder.
6. WARNING! Grip the Die Grinder firmly with both hands.
7. Slowly apply hand pressure to the Control Lever until the desired speed
is obtained.
NOTE: The Die Grinder always turns the Accessory clockwise (reference:
while holding the tool as you would when operating it). Always point
abrasive material away from you.
8. With a firm grip on the Die Grinder, lightly apply accessory to workpiece,
slowly and steadily moving tool to right and left until achieving desired
appearance (finish) on workpiece.
9. If Air Angle Die Grinder requires more force to accomplish task, verify
that it receives sufficient, unobstructed airflow (CFM) and increase pres-
sure (PSI) output of regulator up to maximum air pressure rating of tool.
10. If the tool still does not have sufficient force at maximum pressure and
sufficient airflow, then a larger tool may be required.
11. CAUTION! To prevent tool and accessory failure, resulting in injury:
Do not exceed the tool’s maximum air pressure rating of 90 PSI.
12.Once work is completed, release hand pressure on Control Lever.
13. Turn off air compressor. Slowly squeeze Control Lever to release any
remaining air pressure from Die Grinder. Then disconnect air hose.
14. Remove Accessory from Die Grinder. Store the tool in a clean and dry
location out of the reach of children
