- 11 -
15. Insert the un-slotted end of tube (E) into tube (B1) and secure with a # 8 x 1-1/2" screw, lock
washer and hex nut.
16. Locate coil support tube 30 meter (O) and measure to a point 9-7/8” down from the end of the
plastic insulator. Mark this point with a pencil.
17. Locate coil support tube 30 meter L bracket (O1) and place the tabbed end inside of the coil
support tube 30 meter (O) securing it with a # 8 x 3/4" screw, lock washer and hex nut.
18. Place a #10 washer, lock washer and wing nut on the lower single clamp of coil/capacitor
assembly 30 meter (P).
19. Place a #10 washer, lock washer and hex nut on both upper clamps of coil/capacitor assembly
30 meter (P).
20. Pass the lower single clamp of coil/capacitor assembly 30 meter (P) over the insulator end of
coil support tube 30 meter (O) and slide the coil downward along the tube until the upper edge
of the upper clamp is flush with the end of the insulator. Align the upper clamp with the coil
support tube 30 meter L bracket (O1) and tighten the hex nut.
21. Stretch the coil until the bottom of the bottom clamp on the coil/capacitor assembly 30 meter (P)
is even with the 9-7/8” mark on coil support tube 30 meter (O) and tighten the wing nut.
