- 10 -
9. Stretch the 80 meter (larger) coil on the coil assembly 80/40 meter (C) until the bottom of the
lower clamp is even with the lower mark. Secure with a #10 flat washer, lock washer and wing
nut.
10. Locate the capacitor assembly 80/40 meter (D) and install capacitor bracket 80 meter (D1) on
the larger 200 pF capacitor using the installed screw.
NOTE:
DO NOT USE EXCESSIVE FORCE OR OVER TIGHTEN THE SCREWS ON EITHER
CAPACITOR AS YOU WILL DAMAGE THEM. DO NOT DROP THIS ASSEMBLY AS
YOU MAY FRACTURE THE CAPACITOR’S CERAMIC SHELL.
11. Locate capacitor bracket 40 meter (D2) and install on the smaller 67 pF capacitor as shown.
12. Install the above assembly onto the #10 screw protruding from the tab of the center clamp on the
coil assembly 80/40 meter (C). Align capacitor bracket 80 meter (D1) alongside the larger 80
meter coil of coil assembly 80/40 meter (C). Secure with a #10 flat washer, lock washer and hex
nut.
13. Attach the tab end of capacitor bracket 80 meter (D1) to tube (B) with capacitor bracket clamp
(U) and secure with # 8 x 1" screw, lock washer and a hex nut.
14. Attach the tab end of capacitor bracket 40 meter (D2) to tube (B1) with capacitor bracket clamp
(U) and secure with # 8 x 1" screw, lock washer and a hex nut.
