INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 44 of 116
GB
ERGOLOCK.CB - AD - ST
7102-M004-0_B
• Every
week
and/or when necessary, top up the oil tank
using the filler hole provided closed by a cap or screw
on the lubricator filter.
N.B: This operation should not be carried out by
unscrewing the cup of the lubricator filter.
• The use of synthetic oil may damage the pressure regu-
lator filter.
• Lubricate
weekly
the 5 points shown in the lubrica-
tion plan on the relevant plate on the machine.
• Replace worn out parts immediately, for example:
bead-breaker rollers, lever protector, mounting tool.
• Periodically, at least once every two months, check the
conditions of the rubber protections at point 3.0 Safety
devices. In case of need, replace the damaged parts
requiring them to the manufacturer.
• Periodically (at least every 100 working hours) control
the lubricating level on the reduction gear (
Fig. 48 pos.
1
). To carry out this operation, remove the plug (
Fig.
48 pos. 3
), placed on the proper hole on the frame
and removing the plug (
Fig. 48 pos. 2
) placed on the
reducer.
Fig. 48
13.0 ROUTINE MAINTENANCE
To guarantee the efficiency and correct functioning of the
machine, it is essential to carry out daily or weekly clean-
ing and weekly routine maintenance, as described be-
low.
Cleaning and routine maintenance must be conducted
by authorized personnel and according to the instruc-
tions given below.
• Disconnect the mains power supply before starting
any cleaning or routine maintenance operations.
• Remove deposits of tyre powder and other waste ma-
terials with a vacuum cleaner.
DO NOT BLOW IT WITH COMPRESSED AIR
.
• Do not use solvents to clean the oil/pressure regula-
tor.
• The condensation in the pressure regulator reservoir
must be drained
daily
. Press the connector at the bot-
tom of the regulator to discharge the water. (See
Fig.
47
).
• Periodically check the calibration of lubricator in pres-
sure/oiler gauge unit: one oil drop every 11-15 revolu-
tions of self-centering chuck motor.
• Periodically check the calibration of lubricator
located on beading-out device: one oil drop every com-
plete motion (forward/back) of beading-out device top
and lower arms.
Fig. 47
Pression regulator
Adjusting screw
Air supply
Press to drain condensation
Oiler
IN ORDER TO ALLOW A LONGER
LIFE OF THE FILTER AND OF
ALL MOVING PNEUMATIC DE-
VICES, YOU HAVE TO MAKE
SURE THAT THE SUPPLIED AIR
IS:
• EXEMPT FROM THE LUBRI-
CATING OIL OF THE COM-
PRESSOR;
• EXEMPT FROM HUMIDITY;
• EXEMPT FROM IMPURITY.
THE MANUFACTURER DOES NOT
ACCEPT ANY DAMAGE RESULT-
ING FROM THE FRAILURE TO
OBSERVE THE ABOVE INSTRUC-
TION, AND SUCH FAILURE
COULD INVALIDATE THE WAR-
RANTY!!