User Manual
5
Ⅴ
. Installation instruction
1.
All the electrical power unit and circuit connection must be installed by qualified
electrician with safety standard.
2.
Connection must be based on requirements.
3.
Make sure the rubber feet have been installed securely.
4.
Product should be place in a well ventilated place on solid platform, and we suggest to
least at least 10cm space between the product and the wall or barriers. Also place the
product away from combustible materials, and there should be a fire extinguisher
equipped around.
5.
Remove the packaging film off the surface.
6.
The power wire should be connected according to safety standards. Make sure the voltage
and frequency conform to the parameters. And please install a double pole switch before
connection. When the voltage working, the voltage error should be under
±
10%.
(
Product must be connected to ground.)
7.
Connect the cable to the power supply fixed by using a screwdriver according to the
connection diagram, then loosen the screw inside the power point, and plug in the cable,
make sure the sheet copper compress the power line tightly. If the connection is incorrect,
it may cause joint heating and burning off the power cord.
6.6
EP2T-006-006
Right layer board 2
1
6.7
EP2T-006-007
Main panel of the chamber
1
6.8
EP2T-006-008
Cover board of the chamber
1
6.9
EP2T-006-009
Fixed plate for the pyrocotton
1
6.10 EP2T-006-010
Lamp shade
1
7
EP2T-007
Bottom fixed plate for the pyrocotton
1
8
EP2T-008
Top fixed plate for the pyrocotton
1
9
EP1T-009
Durothermic lamp
1
10
EP2T-010
Binding post
1
11
EP2T-011
Side board
2
12
EP2T-012
Rubber feet
4
13
EP2T-013
Shell
1
14
EP2T-014
Layer board for the chamber
1
15
EP2T-015
PG13.5 cable gland
1
16
EP2T-016
Cable
1
17
EP2T-017
Timer
1
