![background image](http://html.mh-extra.com/html/bushranger/bru36v9201/bru36v9201_operators-manual_2835575014.webp)
14
Operation
Adding Chain Lubricating Oil
• See page 22, figure 7.
WARNING
Never work without chain lubricant. If the saw chain is running without lubricant, guide bar and saw chain can be damaged.
It is therefore essential to check the oil level in the oil level gauge frequently and every time before starting to use the chain
saw.
• Clear surface around the oil cap to prevent contamination.
• Unscrew and remove the cap from the oil tank.
• Pour the oil into the oil tank and monitor the oil level gauge. Ensure that no dirt enters the oil tank while filling.
• Put the oil cap back on and tighten it up. Wipe away any spillage.
• One full oil tank will enable you to use the saw for 20-40 min.
Recommended Chain Lubricating Oil
IMPORTANT
Only use chainsaw oil or adhesive oil for chainsaws. Do not use oil containing impurities, to avoid clogging the tank filter
and permanately damaging the oiler.
IMPORTANT
The chain lubricating oil is bio-degradable. The use of mineral oil or engine oil can have a serious impact on the
environment. It is essential that you use good quality oil to lubricate the cutting parts effectively. Used or poor quality oil
does not guarantee good lubrication and reduces the duration of the chain and bar.
IMPORTANT
Before each machine use, the oil level should be checked and topped up to 1 cm from the rim of the filter. The oil level must
not drop below the <<MIN>> level mark.
Installing Battery Pack
(Refer To Page 20, figure 8)
• Place the battery pack in the chain saw. Align raised ribs on battery pack with grooves in the chain saw’s battery port.
• Make sure the latch on bottom of the battery pack snaps in place and that battery pack is fully seated and secure in the
chain saw before beginning operation.
Holding The Chainsaw
• Always hold the chain saw with your right hand at the rear handle and your left hand at the front handle. Grip both
handles with the thumbs and fingers encircling the handles. Ensure that your left hand is holding the front handle so
that your thumb is underneath.
Starting The Chainsaw
• Before starting for operation, you should install the battery pack in the machine and make sure chain brake is in run
position by pulling chain brake lever / hand guard toward the front handle.
• To start the machine: pull the trigger release, and then press the throttle trigger.
USING THE PRODUCT
Содержание BRU36v9201
