INSTALLATION INTO A CAVITY
DC-X fridges are designed to be installed in a cavity. A gap of minimum 40mm is recommended for the rear. Refer to
the following table for the recommended cut-out dimensions. If you are using the mounting kit, allow an extra 5mm
width for the mounting kit frame and screws.
MODEL
CUT-OUT CAVITY DIMENSIONS (MM)
WIDTH
DEPTH
HEIGHT
DC50-X
385
495
530
DC65-X
455
515
530
DC85-X
480
550
630
DC130-X
530
550
755
EFFICIENT OPERATION
VENTILATION
Ventilation will have a significant impact on the efficient operation of your fridge. A minimum of 2 vents need to be
provided from the rear of the fridge cavity to the outside environment, or to the general area where the fridge is
located. The vents should be located at the bottom and top of the fridge cavity and have a free cross section of
minimum 200cm2 each. By providing free air flow to the compressor area your cooling system will remove heat
faster and the fridge will operate more efficiently.
MOUNTING KIT
The mounting kit is first affixed to the side and top of the fridge cabinet using the screws provided.
Once the fridge has been connected to the power supply and moved into its final position, the mounting kit can be
affixed to the front of the cavity.
OPERATING THE FRIDGE
THERMOSTAT
•
The cooling level can be set between 1 and 7.
•
7 is the coldest setting and 1 is the warmest.
EQUALISING THE FRIDGE
During the first 24 hours of operation, your compressor will operate for longer than usual. This process allows the
internal air temperature, food, drinks, condenser and insulation to equalise.
ENERGY SAVING TIPS
•
Have a much ventilation as possible – the more the better.
•
Keep the fridge out of direct sunlight whenever possible
•
Only open the fridge or freezer door when necessary
•
Allow hot food to cool down before placing inside the fridge
•
Defrost the fridge as soon as a layer of ice forms
•
Set the fridge to be only as cold as necessary
USING THE FRIDGE IN EXTREME HEAT
If you are using your fridge in a very hot area or situation, removing the drip tray will improve cold air circulation
throughout the fridge cabinet. Note the DC130-X and DC85-X models do not have a drip tray.
