Bush WMSAE1012EB, Инструкция по эксплуатации

Страница: 15 / 48

Installing your washing machine
Bringing it all together
Installing your <washing machine>
15
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271 .
Connections
Water inlet hose connections
Important:
This washing machine MUST only be
connected to a cold water supply.
a: Connect the water inlet hose, the angled
connection attaches to the water inlet on the back of
the washing machine. (7)
b: The straight connection attaches to the water supply
valve. (8)
c:
Ensure all seals are in place before connecting.
Important:
Only tighten the hose connection nut by
hand - do not overtighten.
Drain hose connections
Important: The height of the top of the curve in the
drain hose MUST be between 60 - 100cm from the
floor. (9)
Important:
The end of the water drain hose may be
fitted directly to the waste water outlet hole or a special
apparatus mounted on the outlet bracket of the wash-
stand.
Important: Never attempt to extend the water drain
hose by adding extra parts.
Electrical
Any electrical work that is required
to install this washing machine
MUST be carried out by a qualified
electrician.
THIS APPLIANCE MUST BE
EARTHED
Before making any electrical connections, ensure that:
• The power socket is suitable for the maximum power
of the washing machine (fuses in the power circuit
must be 13 amp).
• The supply voltage should be the same as that
indicated in the technical specifications and the
appliance rating plate (located where shown).
• The appliance should be earthed and in compliance
with the applicable law.
• Additional earth cables should not be necessary if the
plug and socket are earthed. If necessary, an additional
earth cable should be attached to the earth terminal on
the back of the washing machine and earthed.
• When installed, the power socket must be within easy
reach.
• The use of adapters, multiple connectors or extension
cables are not recommended.
• The appliance must be connected to a 220-240 volt
50 cycle AC supply by means of a three pin socket,
suitably earthed and protected by a 13 amp fuse.
• Should the fuse need to be replaced, a 13 amp fuse
approved to BS1363/A must be used.
• The plug contains a removable fuse cover that must
be refitted when the fuse is replaced. If the fuse cover
is lost or damaged, the plug must not be used until
a replacement cover has been fitted or the plug is
replaced.
• A damaged plug should be cut off as close to the
plug body as possible, the fuse should be removed and
the plug disposed of safely.
8 7
9