ICS11BTi Instruction Manual
4
Installing the Unit into the ISO Dashboard Slot
Notes:
y
Choose the mounting location where the unit will not interfere with the normal driving
function of the driver.
y
Before finally installing the unit, connect the wiring temporarily and make sure it is all
connected up properly and the unit and the system work properly.
y
Use only the parts included with the unit to ensure proper installation. The use of
unauthorised parts can cause malfunctions.
y
Consult with your nearest dealer if installation requires the drilling of holes or other
modifications of the vehicle.
y
Install the unit where it does not get in the driver’s way and cannot injure the passenger
if there is a sudden stop, like an emergency stop.
y
If installation angle exceeds 30° from horizontal, the unit might not give its optimum
performance.
y
Avoid installing the unit where it would be subject to high temperature, such as from
direct sunlight, or hot air, from the heater, or where it would be subject to dust, dirt or
excessive vibration.
DIN FRONT/REAR-MOUNT
This unit can be installed either from “Front” (conventional DIN Front-mount) or “Rear”
(DIN Rear-mount installation, utilising threaded screw holes at the sides of the unit
chassis). For details, refer to the following illustrated installation methods.
TAKE OUT SCREW BEFORE INSTALLATION
Before installing the unit, please remove the two screws.
30