Bush DWINT125W, Инструкция по эксплуатации

Страница: 15 / 38

15
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on
dishwasher
0345 257 7271.
Installing your dishwasher
Bringing it all together
【
Figure 4b
】
Installation of aesthetic wooden panel
Take away the four short screws
Pin up the four long screws
1. take away the four short screws
2. pin up the four long screws
【
Figure5
】
Tension adjustment of the door spring
Tension adjustment of the door spring
The door springs are set at the factory to the proper
tension for the outer door.
If aesthetic wooden panel are installed, you will
have to adjust the door spring tension.
Rotate the adjusting screw to drive the adjustor to
strain or relax the steel cable (see figure 5).
Door spring tension is correct when the door
remains horizontal in the fully opened position,
yet rises to a close with the slight lift of a finger.
Dishwasher installation steps
1 Install the furniture door to the outer door of the
dishwasher using the brackets provided. Refer to the
template for positioning of the brackets.
2 Adjust the tension of the door springs by using an
Allen key turning in a clockwise motion to tighten
the left and right door springs. Failure to do this
could cause damage to your dishwasher (Illustration 2).
3 Connect the inlet hose to the cold water supply .
4 Connect the drain hose. Refer to diagram.(Figure 6)
5 Connect the power cord.
6 Affix the condensation strip under the work surface
of cabinet. Please ensure the condensation strip is
flush with edge of work surface.
7 Place the dishwasher into position.(Illustration 4)
8 Level the dishwasher. The rear food can be adjusted
from the front of the dishwasher by turning
the Allen screw in the middle of the base of dishwasher
use an Allen key (Illustration 5A). To adjust the front
feet, use a flat screw driver and turn the front feet until
the dishwasher is level (Illustration 5B).
9 The dishwasher must be secured in place. There are
two ways to do this:
A. Normal work surface:Put the installation hook into
the slot of the side plane and secure it to the work surface
with the wood screws (Illustration 6).