Bush DWINT125W, Инструкция по эксплуатации

Страница: 14 / 38

Installing your dishwasher
Bringing it all together
Installing your
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
dishwasher
Caution: 2 people are required to unpack and handle
the appliance, it is recommended that gloves are worn.
Carefully remove all packaging materials including
the foam base, dispose of correctly.
Unpack the dishwasher
The installation position of dishwasher should be near
the existing inlet and drain hoses and power cord.
One side of the cabinet sink should be chosen to
facilitate the connection of drain hoses of the
dishwasher.
Note: please check the accompanying installation
accessories(hook for aesthetic panel,screw)
Installation preparation
Please carefully read the installation instruction.
Illustrations of cabinet dimensions and installation
position of the dishwasher
Preparations should be made before moving the
dishwasher to the installation place.
1.Choose a place near the sink to facilitate the
installation of inlet and drain hoses(see figure 1).
2.If dishwasher is installed at the corner of the
cabinet, there should be some space (illustrated in
figure 2) when the door is opened.
【
Figure 1
】
Cabinet dimensions
top of dishwasher and cabinet and the outer door
aligned to cabinet. Less than 5mm between the
90
°
90
°
600 mm
820mm
100
580mm
80
Space between cabinet
bottom and floor
Electrical, drain and
water supply line
entrances
【
Figure 2
】
Minimum space when the door is opened
Cabinet
Dishwasher
Door of
dishwasher
Minimum space of 50mm
Aesthetic panel's dimensions and installation
1.The aesthetic wooden panel could be processed
according to the Figure 3.
7
2
0
(Unit: mm)
【
Figure 3
】
The aesthetic panel should be processed in accordance
with the illustrated dimensions.
2.Install the hook on the aesthetic wooden panel and put
the hook into the slot of the outer door of dishwasher
(see figure 4a). After positioning of the panel , fix the panel
onto the outer door by screws and bolts(See figure 4b) .
【
Figure 4a
】
Installation of aesthetic panel